ADJUSTMENT - TM-9-2350-256-20

CHAPTER 11 MAINTENANCE OF MAIN WINCH, HOIST WINCH, AND RELATED COMPONENTS

ADJUSTMENT (cont) - TM-9-2350-256-20_1161

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
1147

CHAPTER 11: MAINTENANCE OF MAIN WINCH, HOIST TM 9-2350-256-20 WINCH, AND RELATED COMPONENTS 11-1 SERVICE MAIN WINCH LEVEL WINDER CYLINDER ADJUSTMENT- Continued 2 Loosen and slide back packing gland nut (4) using wrench (5). 3 Slide back seal (6). NOTE Tightening inner cap shortens level winder piston stroke; loosening cap lengthens stroke. Adjust cap at end of cylinder until cable wire winds evenly across winch drum without piling up or falling short at drum ends. 4 Adjust inner cap (7) using wrench (8). NOTE Follow-on maintenance: Install cab subfloor plates if removed (see paragraphs 9-2 through 9-23) 11-2 SERVICE MAIN WINCH BRAKE BAND ADJUSTMENT THIS TASK COVERS Adjustment INITIAL SET-UP Tools: Equipment Conditions: Tool kit, general mechanic's (Appendix C, item 53) Right-front access floor plate removed (see paragraph 9-2) 11-2

Privacy Statement
Press Release
Contact