TM 9-2350-256-2019 Mechanical transmission shaft universal joint.a. Remove subfloor plate (see paragraph 9-13)b. Loosen clamp (27) and pull boot (28) out ofway.c. Rotate joint (29) as necessary to obtain access totwo grease fittings (30).d. Lubricate with GAA through fittings (30)e. Reposition boot and install subfloor plate (seeparagraph 9-12).20 Breather cap-mechanical transmissiona. Remove subfloor plate (see paragraph 9-13).b. Remove breather cap (31) and clean it withdry-cleaning solvent (SD-2) (Appendix D,item 9).c. install cap (31).d. Install subfloor plate (see paragraph 9-12).21 Mechanical transmission fill and level.a. Remove subfloor plate (see paragraph 9-12)b. Before operation, remove cap (31) and bayonetgage (32).c. Check that oil level is to the FULL mark ongage. If necessary, fill mechanical transmissionwith oil (see Table J-1) until FULL mark isreached.d. Start main engine to operate mechanicaltransmission for a few minutes. Stop engineand check oil level again. Add oil, if necessary.e. Install subfloor plate (see paragraph 9-12)Change 1 J-21
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
