TM 9-2350-256-20
J-5 LUBRICATION INSTRUCTIONS-Continued
b. SERVICE FROM CREW COMPARTMENT-Continued
7
Main winch gear case fill and level.
a.
Remove subfloor plate (see paragraph 9-1).
b.
Before operation, remove breather cap (11) and
bayonet gage (12). Check to see that oil level is
to the FULL mark on gage. If level is below
FULL mark, add oil (see Table J-l) until oil
level rises to FULL mark.
c.
Install bayonet gage (12) and cap (11).
d.
Install subfloor plate (see paragraph 9-1).
8
Breather cap-main winch gear case.
a.
Remove subfloor plate (see paragraph 9-1).
b. Remove breather cap (11) and clean it with
dry-cleaning solvent (SD-2) (Appendix D,
item 9).
c.
Install breather cap (11).
d.
Install subfloor plate (see paragraph 9-1).
9
Mechanical transmission oil filter.
a.
Remove subfloor plate (see paragraph 9-12).
b . R e m o v e f i l t e r ( 1 3 ) f r o m m e c h a n i c a l
transmission.
c. Clean filter (13) with dry-cleaning solvent
(SD-2) (Appendix D, item 9).
d. Install filter (13).
e.
Install subfloor plate (see paragraph 9-12).
APPENDIX J: LUBRICATION INSTRUCTIONS
J-16
Change 1
