REMOVAL - TM-9-2350-256-20

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
484

TM 9-2350-256-20 CHAPTER 4: MAINTENANCE OF MAIN ENGINE FUEL, AIR INTAKE, AND EXHAUST SYSTEMS 4-8 REPLACE FUEL LEVEL TRANSMITTER-CONTINUED l Transmitter removal pertains to the eight rear and forward fuel tanks only. a. REMOVAL 1 Remove connector (1). 2 Remove transmitter (2) by removing four screws (3). 3 Remove adapter (4) and gasket (5) by removing six screws (6) and six lockwashers (7). b. INSTALLATION 1 Install adapter (4) with new gasket (5) by installing six new lockwashers (7) and six screws (6) onto fuel tank. 2 Install transmitter (2) with four screws (3) and connect connector (1). NOTE Follow-on maintenance: •Install engine deck (see paragraph 9-51) •Install stowage basket center left floor plate (see paragraph 9-14) 4-9 REPLACE/REPAIR PURGE PUMP/HANDLE/LEVER THIS TASK COVERS a. Removal b. Disassembly c. Assembly d. Installation INITIAL SET-UP Tools: Parts-Continued: Tool kit, general mechanic’s (Appendix C, item 53) •Lockwashers (4) (Appendix G, item 132) Parts: •Lockwasher (Appendix G, item 137) l Bushing (Appendix G, item 8) *Pins, cotter (3) (Appendix G, item 209) l Lockwasher (Appendix G, item 116) Reference: l Lockwasher (Appendix G, item 129) TM 9-2350-256-10 Do not smoke or use open flame when working on fuel system: explosion may occur, causing severe injury or death. NOTE l Push in manual fuel shutoff and turn fuel pump switch to OFF position to shut off fuel to purge pump. l Push in fuel shutoff handle, start engine (refer to TM 9-2350-256-10), and check for leaks. l Handle can be repaired without removing purge pump a. REMOVAL 1 Disconnect two electrical connectors (1). 2 Disconnect fuel line at coupling (2) and fuel line at nipple (3) from purge pump assembly (4) 4-20 Change 1

Privacy Statement
Press Release
Contact