ASSEMBLY - TM-9-2350-256-20

REPLACE/REPAIR FUEL FILLER TUBE AND FILLER STRAINER

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
483

SECTION I: FUEL SYSTEM TM 9-2350-256-20 1 2 3 4 5 6 7 8 d. ASSEMBLY NOTE If replacing gasket (19), cut an approximate 2-inch (in.) (51-millimeter [mm] ) length from new gasket using old gasket as guide. Assemble filler tube grommet assembly (3) by installing spacer plate (18), two gaskets (19 and 20), spacer plate (21), and eight screws (17). e. INSTALLATION Install fuel filler strainer element (16) into fuel tank. Install new gasket (15) and spacer (11). Install lower filler tube (10) with new gasket (11) by installing six new lockwashers (13) and six screws (13). Connect two air vent lines (9). Install upper filler tube (4) with new gasket (5) by installing six nuts (8), six new lockwashers (7), and six screws (6). Install filler tube grommet assembly (3). Install fuel filler tube cap assembly (2). Close fuel fill cover (1). NOTE Follow-on maintenance: Install grille doors (see paragraph 9-57) 4-8 REPLACE FUEL LEVEL TRANSMITTER THIS TASK COVERS a. Removal b. Installation INITIAL SET-UP Tools: Equipment Conditions: Tool kit, general mechanic’s (Appendix C, item 53) • Stowage basket center left floor plate removed Parts: (see paragraph 9-14) • Gaskets (2) (Appendix G, item 60) • Engine deck removed (see paragraph 9-51) • Lockwashers (12) (Appendix G, item 130) Do not smoke or use open flame when working on fuel system: explosion may occur, causing severe injury or death. NOTE l Removal and installation procedures are the same for both the engine compartment and cab 4-19

Privacy Statement
Press Release
Contact