CHAPTER 4: MAINTENANCE OF MAIN ENGINE FUEL, AIR INTAKE, AND EXHAUST SYSTEMSTM 9-2350-256-204-17 REPLACE FUEL/WATER SEPARATOR AUTOMATIC DRAIN SYSTEM ANDSOLENOID VALVE-Continuedb. INSTALLATION1Install mounting bracket (12), ground (15), and clamp (16) with four screws (13) and four new lockwashers(14).2Install control module (3) and clamp (7) with four screws (5) and four flat washers (6).3Connect water level probes (4) and clamp (see paragraph 4-16).4Connect two wiring harness connectors (1 and 2) to control module (3).5Install nipple (17) in solenoid valve (9) IN opening and elbow (18) in solenoid valve OUT opening.6Install solenoid valve (9) on mounting bracket (12) and secure with two assembled washer screws (11).7Install solenoid valve drain tube (10), wiring harness connector (1), and fuel/water separator filter drain hose(8) to solenoid valve (9).8Close drain cock on fuel/water separator (see paragraph 4-16). Activate electric fuel pump until fuel flowsfrom bleeder valve (see paragraph 4-16). Tighten bleeder valve.NOTEFollow-on maintenance: Install powerplant (see paragraph 3-1)4-40
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business