CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS
TM 9-2350-256-20
6-9 REPLACE/REPAIR ELECTRICAL ACCESSORIES PANEL-Continued
10 Disconnect connector (21) and remove lamp holder (22) by removing two screws (23) and two lockwashers
(24).
11 Remove three circuit breakers (25) by removing two screws (26), two lockwashers (27), and two nuts (28) from
each.
12 Disconnect six connectors (29) and remove two lead assemblies (30).
13 Remove wiring harness (31) by removing four
screws (32), four lockwashers (33), and four nuts
(34).
14 Disassemble connectors (see Chapter 6, Section
VII).
c. ASSEMBLY
1
Assemble connectors (see Chapter 6, Section VII).
2
Install wiring harness (31) using four screws (32),
four new lockwashers (33), and four nuts (34).
3
Connect six connectors (29) and install two lead
assemblies (30).
4
Install three circuit breakers (25) using two screws
(26), two new lockwashers (27), and two nuts (28)
for each.
5
Install lamp holder (22) using two screws (23) and
two new lockwashers (24), and connect connector (21).
6-28