TM 9-2350-256-20
CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS
6-59 REPLACE/REPAIR ENGINE WIRING HARNESS (SINGLE VOLTAGE)
(11671816)--Continued
a. REMOVAL
1
Remove seven clamps (30) by removing screw (31) from each.
2
Disconnect connector (1) from governor solenoid (32).
3
Disconnect connector (2) from fuel shutoff (33).
4
Disconnect connector (3) from right side manifold preheat coil (34).
5
Disconnect connector (4) from module auto water drain (35).
6
Remove ground lead (5) from engine (36) by removing screw (37), clamp (38), and two lockwashers (39).
7
Disconnect connectors (6, 11, and 12) from module starter wiring harness (40).
8
Disconnect connector (10) from engine disconnect (41) by removing four screws (42), four lockwashers (43)
and four nuts (44).
6-150
