SECTION V: VEHICLE WIRINGTM 9-2350-256-20a. REMOVAL1 Remove eight clamps (9) by removing screw (10 )and lockwasher (11) from each.2 Disconnect connector (1) from bulkhead disconnect(12).3 Disconnect five connectors (2 through 6) frombulkhead to main engine bracket and rear fuel tanktransmitter wiring harness (13).4 Disconnect two connectors (7 and 8) from bulkheadto APU, master relay, and rigger's lights wiringharness (14).b. DISASSEMBLYDisassemble wiring harness (see Chapter 6, Section VII).c. ASSEMBLYAssemble wiring harness (see Chapter 6, Section VII).d. INSTALLATION1 Connect two connectors (7 and 8) to bulkhead to APU, master relay, and rigger's lights wiring harness (14).2 Connect five connectors (2 through 6) to bulkhead to main engine bracket and rear fuel tank transmitter wiring harness(13).3 Connect connector (1) to bulkhead disconnect (12).4 Install eight clamps (9) using new lockwasher (11) and screw (10) for each.NOTEFollow-on maintenance: Install air inlet doors if removed (see paragraph 9-56)6-185
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
