SECTION V: VEHICLE WIRINGTM 9-2350-256-20b. DISASSEMBLYDisassemble wiring harness (see Chapter 6, Section VII).c. ASSEMBLYAssemble wiring harness (see Chapter 6, Section VII).d. INSTALLATION1 Connect three connectors (13, 14, and 15) to bulkhead to main engine wiring harness and starter relay wiring harness(28).2 Connect connector (12) to circuit breaker (27).3 Connect connector (11) to bulkhead to APU, master relay, and rigger's lights wiring harness (26).4 Connect connector (10) to main engine disconnect (25).5 Connect connector (9) to engine disconnect ground lead assembly (24).6 Connect two connectors (7 and 8) to batteries to master relay, voltage regulators, slave receptacle, and enginedisconnect wiring harness (23).7 Connect two connectors (5 and 6) to bulkhead to main engine wiring harness and starter relay wiring harness (22).8 Connect two connectors (3 and 4) to main engine voltage regulator to engine disconnect wiring harness (21).9 Connect connector (2) to rear fuel tank transmitter (20).10 Connect connector (1) to bulkhead disconnect (19).11 Install 16 clamps (16) using new lockwasher (18) and screw (17) for each.NOTEFollow-on maintenance: Install air inlet doors if removed (see paragraph 9-56)6-189
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
