SECTION V: VEHICLE WIRINGTM 9-2350-256-20b. DISASSEMBLYDisassemble wiring harness (see Chapter 6, Section VII).c. ASSEMBLYAssemble wiring harness (see Chapter 6, Section VII).d. INSTALLATION1 Connect connector (16) to circuit breaker (27).2 Connect seven connectors (9 through 15) to bulkhead to main engine wiring harness and starter relay wiring harness(26).3 Connect connector (8) to main engine disconnect (25).4 Connect three connectors (5, 6, and 7) to batteries to master relay, voltage regulator, slave receptacle, and enginedisconnect wiring harness (24).5 Connect connector (4) to switching relay box (23).6 Connect connector (3) to APU and main engine armature relays to voltage regulator wiring harness (22).7 Connect connector (2) to rear fuel tank transmitter (21).8 Connect connector (1) to bulkhead disconnect (20).9 Install 16 clamps (17) using new lockwasher (19) and screw (18) for each.NOTEFollow-on maintenance: Install air inlet doors if removed (see paragraph 9-56)6-193
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
