SECTION V: VEHICLE WIRING
TM 9-2350-256-20
c. ASSEMBLY
Assemble wiring harness (see Chapter 6, Section VII).
d. INSTALLATION
1 Connect lead (5) to ground using new lockwasher (11) and screw (12).
2 Connect connector (4) to warning lamp (10).
3 Connect two connectors (2) to power switch assembly (9).
4 Connect connector (1) to M239 launcher power switch box assembly outlet (6) using four new lockwashers
(8) and four screws (7).
NOTE
Follow-on maintenance: Install M239 launcher power switch box assembly (see paragraph 15-1)
6-93 REPLACE/REPAIR DRIVER'S VEHICLE EXHAUST SMOKE BRACKET TO
BULKHEAD CONNECTION WIRING HARNESS (11672382)
THIS TASK COVERS
a. Removal
b. Disassembly
c. Assembly
d. Installation
INITIAL SET-UP
Tools:
Parts:
Equipment Condition:
Tool kit, general mechanic's
Lockwashers (14) (Appendix G,
Air cleaner assembly removed
(Appendix C, item 53)
item 116)
(see paragraph 4-24)
WARNING
Be certain MASTER switch is OFF when working on electrical systems to avoid electrical shock and burns.
Connector No.
Electrical Lead To:
Wire No.
1
Gage panel to bulkhead wiring harness connector at bulkhead
T
disconnect
2
Gage panel to bulkhead wiring harness
26B
3
Switch panel to gage panel and miscellaneous switches wiring
27A
harness
4
Driver's vehicle exhaust smoke switch
T
5
Driver's vehicle exhaust smoke switch
26B
6
Driver's vehicle exhaust smoke switch
27A
7
Driver's vehicle exhaust smoke switch
T1
8
Driver's vehicle exhaust smoke indicator light
T2
9
Driver's vehicle exhaust smoke disconnect bracket
27A, 26B, T, T1
6-245