CHAPTER 9: MAINTENANCE OF HULL- AND CAB-RELATED COMPONENTS
TM 9-2350-256-20
9-59 REPLACE EXHAUST DEFLECTOR
THIS TASK COVERS
a. Removal
b. Installation
INITIAL SET-UP
Tools:
Parts--Continued:
Tool kit, general mechanic's (Appendix C, item 53)
Lockwashers (6) (Appendix G, item 138)
Pins, cotter (2) (Appendix G, item 212)
Parts:
Lockwashers (2) (Appendix G, item 132)
Personnel Required
Lockwashers (3) (Appendix G, item 134)
Two
a. REMOVAL
1
Remove exhaust deflector (1) by removing screw (2) and lockwasher (3) from each of three hinges (4). Unlatch two
levers (5) at top end by removing nut (6), lockwasher (7), and flat washer (8) from each.
2
Remove two levers (5) by removing cotter pin (9), pin (10), and two flat washers (11) from each side.
3
Remove three hinges (4) from exhaust deflector (1) by removing two screws (12), two lockwashers (13), and two
nuts (14) from each.
b. INSTALLATION
1
Install three hinges (4) to exhaust deflector (1) with two screws (12), two new lockwashers (13), and two nuts (14) on
each.
2
Install two levers (5) to exhaust deflector (1) with new cotter pin (9), pin (10), and two flat washers (11) on each.
3
Install exhaust deflector (1) with three screws (2) and three new lockwashers (3). Latch two levers (5) at top end
with flat washer (8), new lockwasher (7), and nut (6) on each.
9-104
