TM 9-2350-256-34-1(d) Remove the guard assembly (16) by releas-ing the two fasteners attaching the guard to theheater housing (28). Cut the two cable assemblystraps (37).(b) Remove two flag terminals on one end ofthe ignition control (25). Remove two motor leadsmarked 2 and 4 by removing two screws (42) on theterminal strip of the electrical inlet assembly (36).(c) Remove four screws (2) that secure theblower assembly (1) to the heater housing (28).(d) Feed motor leads and voltage limiter leadthrough grommet (33) and slide blower assemblyfrom the heater.(e) Refer to figure 3-10.3 and disassemble theblower assembly as follows:Legend for figure 3-10.3:123456789101112131415161718192021222324ScrewAir inlet louverBlower housing assemblyScrewVoltage limiter assemblyVentilation blower wheel assemblyMotorBracketScrewSecondary blower cover assemblyNutCombustion blower wheel assemblyDiode mounting assemblyNutNutCable assembly strapCable assemblyScrewScrewSpacer sleeveWasherResistorScrewMotor power lead3-18.2Change 4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business