TM 9-2350-256-34-1
(e) Install the two remaining motor mounting
brackets (8, fig. 3-10.3) with screws (4).
(f) Slide the motor into position as shown in
figure 3-10.11 making sure that the screw which at-
taches the diode mounting assembly ground lead is
in line with the voltage limiter. Secure the motor
flange to the mounting brackets with three screws
(9, figure 3-10.3).
(g) Bundle together the three leads and tie
them with a cable assembly strap (16) or lacing cord.
(h) Loosen the setscrew in the ventilation
blower wheel assembly (6) and reposition the wheel
on the motor shaft to achieve the specified clear-
ance between the blower wheel and the blower
housing assembly (3), as shown in figure 3-10.12.
Tighten the setscrew to secure the adjustment.
3-18.24
Change 2
