TM 9-2350-256-34-1
(4) Installation. Install the accessories panel leads
and wiring harness in reverse order of removal, being
careful to match circuit number markers to the correct
receptacles as shown in View B, figure 2-19.
m
Miscellaneous Individual Wiring Harnesses,
Leads and Cables. ’
(1) General The various wiring harnesses, leads
and cables comprising the powerplant and hull main
wiring harnesses can be removed individually. Refer to
paragraphs 2-21 f and g for those requiring special
handling.
(2) Removal Remove interfering components as
required for access at various points. Disconnect
cable connectors, loosen or remove any cable clamps
and remove wiring harness, lead or cable.
(3) Installation Install wiring harness, lead or cable,
tighten or install cable clamps and connect cable
connectors in reverse order of removal.
Always take care that the cables being connected bear
the same circuit numbers.
n.
Storage Batteries. Refer to TM 9-2350-256-
20 for removal and installation instructions for the vehicle
storage batteries.
2-22. Main Winch Cable a Removal. Pay out cable (TM
9-2350-256-10) prior to removing it from the vehicle.
Refer to TM 9-2350-256-20 for removal and installation
instructions for main winch.
2-44 CHANGE 7
