DIRECT SUPPORT AND GENERAL SUPPORT
Section I. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
Tools, equipment, and maintenance parts, over and above those available to the using organization, are issued to direct
and general support maintenance personnel.
Repair parts are listed in TM 9-2350-256-34P-2, which is the authority for requisitioning replacements. It is important
that careful troubleshooting be used to determine, whenever possible, what parts are to be replaced before the
component is torn down for repair.
Common Tools and Equipment
Standard and commonly used tools and equipment having general application are authorized for issue by Tables of
Allowances and Tables of Organization and Equipment.
Special Tools and Equipment
The special tools and equipment, listed in table 2-1 and illustrated in figure 2-1, are the only special tools and
equipment necessary to perform the maintenance operations described in this technical manual. Refer to TM 9-2350-
256-34P-2 for special tools and equipment allocations and requisitioning authority.
Table 2-1. Special Tools List
Used with puller 8708712 to remove
spade hydraulic cylinder pins.
Eye, main winch
Removing and installing main winch
Eye, hoist winch
Removing and installing hoist winch
Used with bushing 4730-00-186-3024
to check power takeoff lubricating
oil pressure and power takeoff
clutch oil pressure. (See TM9-
Type II, Size
1/4-18 x 1/8-27
Used with gage 7950330. (See TM
Checking main winch system
pressure, hoist winch system
pressure, spade system. pressure,
boom system pressure, or auxiliary
hydraulic system pressure. (See
Guide, spade shaft
Used with handle 10867499 to install
the spade shaft through the oil