TM 9-2350-256-34
0034 00
1.
Remove grommet (hidden) (1) to pull connectors through hole and disconnect two leads (2) of wiring harness (3) to rigger's
light.
2.
Disconnect two leads (4) to B.O. marker.
3.
Remove screw (5), washer (6), and clamp (hidden) (7).
NOTE
Perform the following steps at rear--engine compartment.
4.
Remove four screws (8), washers (9), and clamps (10) from wiring harness (3).
5.
Remove screw (11), washer (12), and clamp (hidden) (13).
0034 00-2
