TM 9-2350-256-34
0065 00
Assembly
1.
Install adapter (62), thrust washer (61), and nut (60) to mechanical transmission (51). Tighten nut on shaft to 125150 lb-ft
(169203 Nm) torque, and stake sleeve on nut into keyway on shaft.
2.
Install oil filter (59), two lockwashers (58), and screws (57) on mechanical transmission (51).
3.
Install hose assemblies (55 and 56) on mechanical transmission (51).
4.
Attach sling to lifting eye (52).
5.
Install mechanical transmission (51), four lockwashers (54), and screws (53) on support (47).
6.
Install hose assembly and valve (50) and fitting (49) on mechanical transmission (51).
7.
Attach sling to lifting eye (44) of main hydraulic pump (40).
8.
Install main hydraulic pump (40), four lockwashers (46), and screws (45).
NOTE
Steps 9 and 10 are for vertical alignment.
9.
Place straight edge across top of opposing shaft coupling hubs and measure difference in height with a feeler gage. If main
hydraulic pump hub is lower than mechanical transmission hub, perform step 10; if both hubs are level, proceed to step 11.
0065 00-8