TM 9--2350--292--10
TRACK INSTALLATION -- CONTINUED
0110 00
23. Using tanker’s bar bring both ends of track (1) together and install track connecting fixtures (12) .
24. Tighten track connecting fixtures (12) evenly to bring link pins (13) together.
25. Install center guide (14) and two end connectors (15), but do not tighten.
26. Remove track connecting fixtures (12) by using sledgehammer drive on two end connectors.
27. Tighten bolt on center guide and install two wedges and two bolts on two end connectors.
28. Start main engine (WP 0012 00) and shift transmission selector to R (WP 0014 00).
29. Release brakes and slowly move vehicle backward until connection point is on curve of compensating idler wheel.
Tighten bolts on end connector.
30. Adjust track tension (WP 0103 00 or WP 0104 00).
31. Notify unit maintenance to torque end connector and center guide bolts as soon as possible. Torque bolts again
after 50 miles.
32. Install fender section (18) with lockwasher (17) and screw (16).
33. Close skirts #1, #3, #5 and #7 (WP 0102 00).
2
13
1
12
14
15
16
17
18
END OF TASK
0110 00--3/4 blank
