TM 9--2350--292--20--1
FUEL TRANSFER PUMP HOSE ASSEMBLIES AND FITTINGS
REPLACEMENT -- CONTINUED
0202 00
Installation--Continued
6. Install retaining ring (10), quick--disconnect coupling half (9) and quick--disconnect cap (8) on bulkhead.
7. Connect quick--disconnect cap (8) on quick--disconnect coupling half (9).
NOTE
A minimum of two decals shall be applied to the hose as-
sembly. A decal shal be wrapped around the hose as-
sembly within 5.00 inches (127.00 mm) of each end. The
maximum allowable distance between decals shall be
36.00 inches (0.91 m). The word “FUEL” shall be visible
after application.
8. Install decals (21) on two hose assemblies (1 and 11), if damaged or missing.
9. Install pipe elbow (7) and one end of hose assembly (1) on bulkhead.
10. Install loop clamp (6), new lockwasher (5) and screw (4) on hose assembly (1).
11. Install pipe elbow (2) and other end of hose assembly (1) on fuel transfer pump assembly (3).
Figure 16
7
1
4
5
6
2
3
8
9
10
21
21
11
NOTE
FOLLOW--ON MAINTENANCE:
Close defuel access door (TM 9--2350--292--10)
Install powerpack (WP 0188 00)
Open fuel shut--off valves (TM 9--2350--292--10)
END OF TASK
0202 00--5/6 blank
