TM 9--2350--292--20--1
0051 00--1
ENGINE USES EXCESSIVE FUEL
0051 00
THIS WORK PACKAGE COVERS:
Engine Uses Excessive Fuel
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
STE--ICE--R (item 85, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Personnel Required
Two
Is STE--ICE--R available?
no
yes
Go to Step I.
A
B 1. Setup STE--ICE--R for operation
(TM 9--4910--571--12&P).
2. Connect STE--ICE--R harness W1 to vehicle
harness 4W800 J1 DCA connector.
3. Enter vehicle ID (VID) 04.
4. Dial 01 into VTM and press and release “TEST”.
5. When VTM shows “CON” enter 24 into TEST
SELECT and press TEST until “CAL” is shown
on VTM and release TEST.
6. Press and release TEST.
7. Crank engine for 10 seconds while holding fuel
shutoff switch in OFF. Record results.
8. Start engine (TM 9--2350--292--10). Record
results.
9. Shut engine down (TM 9--2350--292--10).
Does VTM show PASS?
no
yes
CONTINUED ON NEXT PAGE
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
Go to Step D.
