TM 9--2350--292--20--1
0066 00--1
ALL SIGNALS AT REMOTE TERMINAL UNIT CONNECTOR J1 ARE BELOW
VALID RANGE OR OPEN
0066 00
THIS WORK PACKAGE COVERS:
All Signals At Remote Terminal Unit Connector J1 Are Below Valid Range Or Open
INITIAL SETUP:
Tools and Special Tools
SPORT with Enhanced Diagnostics System
(item 133, WP 0717 00)
Multimeter (item 84, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
SPORT connected to Enhanced Diagnostics System
remote terminal (WP 0086 00)
Enhanced Diagnostics System POWER switch OFF
Is wiring harness 4W502 properly connected?
no
yes
no
yes
A
B
1. Open left and right side engine deck grilles
(TM 9--2350--292--10).
2. Ensure that wiring harness 3W501 is properly
connected to all four sensors in the engine
compartment (WP 0677 00).
Are sensors connected to wiring harness 3W501?
Properly connect wiring har-
ness 3W501 to all
sensors in the engine
compartment (WP 0677 00).
Verify fault is corrected.
Properly connect wiring harness
4W502 (WP 0678 00). Verify
fault is corrected.
1. Ensure that wiring harness 4W502 connector
P1 is connected to remote terminal unit
connector J1.
2. Remove subfloor plate #29 (WP 0454 00).
3. Ensure that wiring harness 4W502 connector
P2 is connected to wiring harness 3W501
connector J1.
CONTINUED ON NEXT PAGE
FORWARD
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.