TM 9--2350--292--20--1
0067 00--1
ALL SIGNALS AT REMOTE TERMINAL UNIT CONNECTOR J2 ARE BELOW
VALID RANGE OR OPEN
0067 00
THIS WORK PACKAGE COVERS:
All Signals At Remote Terminal Unit Connector J2 Are Below Valid Range Or Open
INITIAL SETUP:
Tools and Special Tools
SPORT with Enhanced Diagnostics System software
loaded (item 133, WP 0717 00)
Multimeter (item 84, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
SPORT connected to Enhanced Diagnostics System
remote terminal (WP 0086 00)
Enhanced Diagnostics System POWER switch OFF
Is wiring harness 4W504 properly connected?
no
yes
no
yes
A
B
1. Remove subfloor plates #10, #15 and #18
(WP 0454 00).
2. Ensure that wiring harness 4W504 is properly
connected to sensors on the boom shutoff
valve, hoist winch motor and wiring harness
2W505 connector P1 to the main winch.
Is wiring harness 4W504 properly connected?
Properly connect wiring
harness 4W504 (WP
0680 00). Verify fault is
corrected.
Properly connect wiring harness
4W504 (WP 0680 00). Verify
fault is corrected.
Ensure that wiring harness 4W504 connector P1 is
connected to remote terminal unit connector J2.
CONTINUED ON NEXT PAGE
FORWARD
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
