TM 9--2350--292--20--1
0136 00--1
CHARGE FILTER (RETURN FILTER) CLOGGED LIGHT STAYS ON.
0136 00
THIS WORK PACKAGE COVERS:
Charge Filter (Return Filter) Clogged Light Stays On
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Multimeter (item 84, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Subfloor plate 22 removed (WP 0454 00)
Personnel Required
Two
Did CHARGE FILTER (RETURN FILTER) CLOGGED
light stay on?
1. Reset clogged filter switch push button on
hydraulic filter manifold.
2. Turn vehicle MASTER switch ON, start engine,
engage PTO and set engine speed to 1800
rpm (TM 9--2350--292--10). Observe CHARGE
FILTER (RETURN FILTER) CLOGGED light.
3. Reduce engine speed to idle, disengage PTO,
shut down engine and turn vehicle MASTER
switch OFF (TM 9--2350--292--10).
no
yes
A
CONTINUED ON NEXT PAGE
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
Fault corrected.
Did push button pop back out?
Check position of clogged filter switch push button.
B
no
yes
Replace clogged filter switch
on hydraulic filter manifold
(WP 0553 00). Verify fault is
corrected.
FORWARD
