TM 9--2350--292--20--1
0187 00--28
0187 00
PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING
LUBRICATION INSTRUCTIONS -- CONTINUED
TABLE 1 PREVENTIVE MAINTENANCE CHECKS AND SERVICES
INCLUDING LUBRICATION INSTRUCTIONS, HOURLY OR ON--CONDITION -- CONTINUED
ITEM
NO.
NOT FULLY
MISSION
CAPABLE
IF:
PROCEDURE
LOCATION
ITEM TO
CHECK/
SERVICE
INTERVAL
HOURLY (H) OR
ON--CONDITION
(OC)
BATTERY OR
ENGINE
COMPARTMENT
5
OC
Transmission and
Output Reduction
Drive Oil Change
-- Continued
r. Operate engine (TM 9--2350--292--10)
and warm transmission oil to a
temperature between 180_ to 200_F (82_
to 93_C). To reach desired transmission
oil temperature it may be necessary to
perform high range stall. To perform high
range stall: depress and hold brake pedal
in applied position, place transmission in
3rd range and run engine at full throttle for
not longer than 30 seconds. Return
engine speed to idle. If required, repeat
procedure after 60 seconds of idling to
attain proper transmission oil temperature.
s. Shut down engine
(TM 9--2350--292--10).
CAUTION
To verify that proper transmission oil lev-
el is present, it is very important that
transmission oil is correct temperature
and that correct amount of time (3 to 5
minutes) has passed before reading oil
gauge rod. Failure to comply may result
in an inaccurate oil level reading. If the
vehicle is operated with transmission oil
level below ADD mark, reliability and du-
rability of the transmission assembly
may be reduced.
