TABLE 1 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, HOURLY OR ON--CONDITION (cont)

TABLE 1 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, HOURLY OR ON--CONDITION (cont) - TM-9-2350-292-20-1_854

TABLE 1 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, HOURLY OR ON--CONDITION (cont) - TM-9-2350-292-20-1_856

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
810

TM 9--2350--292--20--1 0187 00--29 0187 00 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS -- CONTINUED TABLE 1 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, HOURLY OR ON--CONDITION -- CONTINUED ITEM NO. NOT FULLY MISSION CAPABLE IF: PROCEDURE LOCATION ITEM TO CHECK/ SERVICE INTERVAL HOURLY (H) OR ON--CONDITION (OC) BATTERY OR ENGINE COMPARTMENT 5 OC Transmission and Output Reduction Drive Oil Change -- Continued t. Remove oil filler tube cap and gauge rod (4) from oil filler tube. Clean oil gauge rod. Install oil filler tube cap and gauge rod (4) into transmission oil filler tube. Remove oil filler tube cap and gauge rod (4) and verify that transmission oil level is between ADD and FULL marks on oil filler tube cap and gauge rod (4). NOTE Excess oil may be removed from transmission using the AOAP valve. u. If indicated oil level is above FULL mark on the oil filler tube cap and gauge rod (4), remove excess oil from transmission until oil level is indicated between ADD and FULL mark on oil filler tube cap and gauge rod (4). NOTE 1/2 inch (12.7 mm) on oil gauge rod equals about one gallon of oil. v. If indicated oil level is below ADD mark on oil filler tube cap and gauge rod (4), add enough proper grade oil (WP 0187 00--25) to transmission to bring oil level between ADD and FULL marks on oil filler tube cap and gauge rod (4). OIL GAUGE ROD 4 CHECK OIL -- ENGINE STOPPED

Privacy Statement
Press Release
Contact