TM 9--2350--292--20--20361 00--8HYDRAULIC BRAKE HOSE ASSEMBLY, BLEED VALVE MANIFOLD ANDASSOCIATED PARTS REPLACEMENT (NEW CONFIGURATION)-- CONTINUED0361 00Installation1. Install angle (62) to floor plate (49) with new lockwasher (71), flat washer (72) and screw (70).2. Install brace (63) to APU control box mount (69) with two new lockwashers (67), two flat washers (68) and twoscrews (66).3. Apply a thin even coat of clean lubricant to all new preformed packings prior to installation.4. Install elbow (51), elbow (55), two new preformed packings (64) and manual pull valve (65) in bleed valve man-ifold (52). Elbow (51) should be oriented so it points toward the floor of the vehicle when bleed valve manifold(52) is installed. Elbow (55) should point away from the manual pull valve (65).5. Install bleed valve manifold (52) on angle (62) and bracket (63) with two screws (61), two flat washers (60), twonew lockwashers (59) and two nuts (58).6. Install brake pressure gauge (56) and new preformed packing (57) in bleed valve manifold (52).7. Install elbow (54) in floor plate (49).Figure 167B496368666758 5960707172585960625756645161556554695264
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business