TM 9--2350--292--20--2
0667 00--37
DEEP WATER FORDING KIT -- CONTINUED
0667 00
Removal--Continued
BILGE PUMP (CONTINUED)
4. Remove two screws (26), two lockwashers (27), two clips (24) and tube assembly (23) from rear of main engine
air inlet (25). Remove two clips (24) from tube assembly (23). Discard lockwashers.
5. Loosen two hose clamps (21), remove tube assembly (23) from hose (22) and hose (22) from adapter (20). Re-
move two hose clamps (21) from hose (22).
6. Remove adapter (20) from adapter (19).
7. Loosen hose clamp (14) and remove hose (13) from adapter (19).
8. Remove two screws (15), two lockwashers (16) and adapter (19) with gasket (18) from top exterior of hull. Dis-
card lockwashers and gasket.
9. Install cover (17) on top exterior of hull, secure with two screws (15) and two new lockwashers (16).
Figure 356
13
14
17
16
15
19
16
15
20
21
23
27
26
24
21
22
18
25
