TM 9--2350--292--20--2
0583 01--2
HYDRAULIC RESERVOIR HYDRAULIC LINES AND FITTINGS
REPLACEMENT (NEW CONFIGURATION) -- CONTINUED
0583 01
Removal--Continued
WARNING
Hydraulic system pressure is rated 4450 psi. Do not
torque hydraulic fittings or perform removal procedures
when hydraulic system is pressurized. Discharging sys-
tem pressure before performing any maintenance proce-
dures will prevent injury to personnel.
Eye protection will be worn when performing mainte-
nance procedures on all hydraulic components to prevent
injury to personnel.
CAUTION
Cap all hydraulic lines and plug all hydraulic ports to pre-
vent contamination. Failure to comply may result in dam-
age to hydraulic system.
All serviceable components must be placed in plastic
bags to prevent contamination of hydraulic system during
installation.
NOTE
All hydraulic lines and components must be tagged be-
fore removal for identification during installation.
Place rags under hydraulic connections to catch any hy-
draulic fluid that spills during maintenance. Dispose of
fluid--soaked rags in accordance with standard operating
procedure.
1. Remove clamps, clips and attaching hardware securing hose assemblies, lines and fittings to vehicle as shown in
legend and illustration. Discard lockwashers.
2. Remove hose assemblies, lines, fittings and filler cap in accordance with the following legend and illustration.
Discard lockwashers and preformed packings.
3. Inspect parts for damage and replace as required.
