TM 9--2350--292--20--1
0280 00--1
TROUBLE LIGHT ASSEMBLY REPAIR
0280 00
THIS WORK PACKAGE COVERS:
Removal, Disassembly, Assembly, Installation
INITIAL SETUP:
Tools
General mechanics tool kit (item 1, WP 0717 00)
Electrical heat gun (item 34, WP 0717 00)
Soldering gun (item 111, WP 0717 00)
Materials/Parts
Lockwashers (2) (item 38, WP 0718 00)
Lockwasher (item 405, WP 0718 00)
Lockwashers (6) (item 406, WP 0718 00)
Adhesive (item 25, WP 0716 00)
Heat shrink insulation tubing
Solder (item 8, WP 0716 00)
Soldering flux (item 63, WP 0716 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Battery power disconnected (WP 0256 00)
Personnel Required
Two
References
TM 9--2350--292--10
TB--SIG 222
Removal
1. Disconnect wiring harness 4W153 connector P3 (1) from J1 on trouble light assembly (2).
2. Remove two screws (3), two lockwashers (4) and trouble light assembly (2). Discard lockwashers. Ground wire
(not shown) from 4W153 connector P3 is installed under one of the two screws (3).
Disconnect ground wire when applicable screw is removed and tag to aid in installation.
Figure 90
1
2
3
4