TM 1-1680-320-13&P
0013 00
INTERVAL
ITEM
ITEM TO BE
PROCEDURES
NO.
INSPECTED
D
M
Q
A
15
Actuator Assembly
Check adjustment of upper limit actuator assembly by
*
measuring distance between top of actuator and cable
guide. Dimension should be 0.75 inch (1.91 cm). Press
up on actuator arm until switches are engaged. Measure
distance between top of arm and cable guide.
Dimension should be 0.44 inch (1.12 cm). Adjust
actuator assembly in accordance with WP 0020 00.
Attach spring scale to pressure roller assembly and
16
*
Pressure Roller
check for a minimum tension of 35 pounds. Remove
springs and check roller for smooth operation. Refer to
17
*
Sheave Assembly
Sighting along cable assembly, inspect sheave
assembly, through cable cutter, and towards winch
assembly, for wear by observing hoist cable for
recessing. Cable assembly shall not contact inside
surface of cable cutter.
18
*
Drum Assembly
Visually inspect for cracks, dents, or nicks. Inspect drum
grooves for distortion, abnormalities, and uneven wear.
Visually inspect cable kicker with an inspection mirror for
cracks, dents, or nicks.
Check alignment of drum assembly by removing
pressure roller cover. While retracting cable, observe
cable travel through cable cutter assembly. Cable
should not contact cable cutter. If required, align drum
assembly in accordance with WP 0024 00.
19
*
Umbilical Cable
NOTE
Check aircraft connection point.
Visually inspect for cuts, tears, fraying, or broken
insulation. Check for security of electrical connectors.
Inspection shall be in accordance with WP 0036 00.
Rescue Hoist
Perform operational checks in accordance with
20
*
End of Work Package
0013 00-4
