TM 1-1680-320-13&P
0014 00
HIGH PERFORMANCE RESCUE HOIST ASSEMBLY
CLEANING UNDER USUAL CONDITIONS
INITIAL SETUP
Personnel Required: 2
References:
UH-1: 15N, Helicopter Repairer
Avionic Cleaning and Corrosion
UH-60: 15T, Helicopter Repairer
Prevention/Control TM 1-1500-344-23 series
Hoist Certified: 91W, Flight Medic
Parts/Materials:
Cleaning Solvent (WP 0047 00, Table 1, Item 12)
Cloth, Low-lint (WP 0047 00, Table 1, Item 13)
Grease (WP 0047 00, Table 1, Item 14)
Lubricating Oil
Lubricant, WD-40 or equivalent
Tools and Special Tools:
Air Source, 35 psi (241.3 kPa)
WARNINGS
Perform all cleaning in a well lit, clean, and properly ventilated room.
To avoid injury to personnel from broken wire strands, leather gloves must be
worn at all times when handling cable assembly.
Prolonged or repeated contact with lubricating oil may irritate the eyes and
skin. Long term use without hand protection may cause dermatitis. Breathing
mists may cause respiratory irritation. If there is any prolonged contact with
skin, wash area with soap and water. Remove saturated clothing. If solution
contacts eyes, flush eyes with water immediately. If oil is swallowed, do not
try to vomit; aspiration may damage lungs. Get immediate medical attention.
When handling liquid, wear rubber gloves and chemical splash proof
goggles. Wear NIOSH/MSHA approved respirator if mists exceed
established exposure limits.
CAUTION
Do not clean parts with chlorinated solvents, such as freon, perchloroethylene,
trichloroethane, carbon tetrachloride, etc. Do not use any type of silicone grease
on any components.
