TM 1-1680-320-13&P
0023 00
3. Screw thermal switch (4) into winch housing (5).
NOTE
Ensure there is enough braiding to fold back over lockwire.
4. Secure thermal switch wiring harness electrical braid by wrapping lockwire around thermal switch (4) using
0.020 lockwire (minimum 2 wraps).
5. Install heat shrink tubing over electrical braid onto thermal switch (4).
6. Install clamp (3) onto connector (2) by inserting screw (1).
7. Install drum assembly in accordance with WP 0024 00.
8. Install electric drive motor in accordance with WP 0021 00.
9. Install limit switch drive assembly in accordance with WP 0034 00.
10. Service winch assembly in accordance with service procedures located on page 0022 00-13.
INSTALLATION
1. Install winch assembly (1) onto lower support assembly (7).
2. Install washers (9) and bolts (8).
3. Torque bolts 160-190 in. lbs.
4. Install boot (4) onto motor air duct (5) and control panel fan plenum (6).
5. Install bands (3) and clips (2) on boot (4).
6. Install upper support assembly in accordance with WP 0028 00.
7. Install boomhead support assembly in accordance with WP 0018 00.
8. Install cable assembly in accordance with WP 0016 00.
