TM 1-1680-320-13&P
0026 00
HIGH PERFORMANCE RESCUE HOIST ASSEMBLY
BOOM POSITION SUPPORT ASSEMBLY - ADJUST
INITIAL SETUP
Personnel Required: 1
References:
UH-1: 15N, Helicopter Repairer
AVUM/AVIM Manual for General Aircraft
UH-60: 15T, Helicopter Repairer
Maintenance TM 1-1500-204-23 series
Hoist Certified: 91W, Flight Medic
Parts/Materials:
Blue Locktite Compound
Lockwire (WP 0047 00, Table 1, Item 21)
Tools and Special Tools:
Tool Kit, Aircraft Mechanic
NSN 5180-00-323-4692
WARNING
Commander should determine who is qualified to perform this maintenance
function.
NOTE
Adjustment of hoist boom rotation limit switches will permit rescue hoist to travel
205 (rotation in and/or out of helicopter).
1. To perform adjustment while hoist is on assembly stand, simulate helicopter floor positions Station (STA)
82.05 and Buttline (BL) 35.10 and mark as follows:
a. Mark a line 10 inches (25.3 cm) long out from stud along station line 82.05.
b. Mark a line 10 inches (25.4 cm) long aft from stud along butt line 35.10.
