GOV. CONTROLS & CARB. LINKAGE
Models 190000, 200000, 230000, 240000, 300000, 320000
REMOTE GOVERNOR CONTROL
Attach remote control casing and wire as shown in
Figure 93 or Figure 94. Do not change the position of
the small elastic stop nuts. They provide for a governed
idle speed and protection against overspeeding.
THUMB NUT ADJUSTMENT
Remove thumb nut and upper elastic stop nut. Replace
thumb nut and adjust to desired operating speed. See
Figure 95. Do not change the position of the lower
elastic
stop
nut.
It
provides
protection
against
overspeeding .
GOVERNED IDLE
All engines in Model Series 243400, 300400, 320400
and some Model Series 23D and 233400 engines use
two governor springs as shown in Figures 96 and 97.
The shorter spring keeps the engine on governor, even
at idle speed. If moderate loads are applied at idle, the
engine will not stall.
TO ADJUST FOR GOVERNED IDLE
First make final carburetor mixture adjustments. Then
place remote control in idle position. Hold throttle shaft
in closed position and adjust idle screw to 1000 R.P.M.
Release the throttle. With remote control in idle position,
adjust upper elastic stop nut to 1200 R.P.M. See Fig. 97.
MODELS 190000, 200000, 230000, 240000, 300000, 320000
Fig. 93
Fig. 94
Fig. 95
Fig. 96
Fig. 97
12