TM 9-2350-238-34-2
2-24. MAINTENANCE OF WINCH CONTROL CYLINDER (CONT).
REASSEMBLY (CONT)
6 Install plate positioner spacer (13),
setscrew (14), head breather machine
thread plug (15), and internal retaining
ring (16) on cylinder (5).
t e s t
2 Connect hydraulic line to inlet port of
cylinder.
3 Apply 3000 psi (20,685 kPa) pressure and
Hydraulic system is under high
hold for 5 minutes. If leakage occurs, re-
pressure. Follow hydraulic system
place winch control cylinder.
safety procedures to prevent injury
(TM 9-2350-238-20-2), Wipe up
4 Release pressure. Remove hydraulic line
spilled hydraulic fluid.
and cover inlet port.
1 Refer to TM 9-4940-468-14 for test setup
and testing procedures.
2-68
