TM 9-2350-256-20-1
0064 00
CORRECTIVE ACTION Continued
2.
Reconnect connector to MECH TRANSMISSION OIL PRESSURE light. Disconnect gage panel to
bulkhead wiring harness from gage panel. Place red lead of multimeter in socket K of wire 27 and
black lead to ground. Turn MASTER switch on and check for voltage. Turn MASTER switch OFF.
If voltage is present, repair/replace wire 27/27K of gage panel wiring harness (see WP 0193 00). If
voltage is not present, go to step 3.
3.
Reconnect gage panel to bulkhead wiring harness to gage panel. Install ground strap (5), two lock-
washers (4), two screws (3), gage panel (6), three lockwashers (2), and three screws (1) to mounting
brackets. Remove three screws (7), three lockwashers (8), ground lead (9), and flat washer (10), and
release main switch panel (11) from mounting brackets. Disconnect switch panel to gage panel and
miscellaneous switches wiring harness from switch panel. Place red lead of multimeter in pin N and
black lead to ground. Turn MASTER switch on and check for voltage. Turn MASTER switch OFF. If
voltage is present, go to step 5. If voltage is not present, go to step 4.
0064 00-4
