TM 9-2350-256-20-1
0065 00
CORRECTIVE ACTION Continued
12. Reconnect connector to master warning light. Disconnect gage panel to bulkhead wiring harness from
gage panel. Place a jumper wire from pin K to socket K. Place red lead of multimeter in pin A of wire
509 and black lead to ground. Turn MASTER switch on, start engine, set to idle, and check for voltage.
Turn engine and MASTER switch OFF. If voltage is present, repair/replace wire 509 of gage panel
wiring harness (see WP 0193 00). If voltage is not present, reconnect gage panel to bulkhead wiring
harness and go to step 13.
13. Open air inlet doors. Disconnect bulkhead to engine bracket and rear fuel tank transmitter wiring
harness from bulkhead disconnect. Place red lead of multimeter in socket H of wire 509 and black lead
to ground. Turn MASTER switch on, start engine, set to idle, and check for voltage. Turn engine and
MASTER switch OFF. If voltage is present, go to step 14. If voltage is not present, repair/replace wire
509 of gage panel to bulkhead wiring harness from gage panel to bulkhead (see WP 0194 00 for dual
voltage; 0195 00 for single voltage).
0065 00-10
