TM 9-2350-256-20-1
0083 00
CORRECTIVE ACTION Continued
3.
Reconnect headlight base assembly to headlight assembly. Disconnect wire 20 of headlight base
assembly from switch panel to head lamps and bulkhead wiring harness. Place red lead of multimeter
on male connector of wire 20 and black lead to ground. Turn MASTER switch ON, press B.O.
MARKER key and ENTER key on main light switch, and check for voltage. Turn MASTER and main
lighting switches OFF. If voltage is present, repair/replace wire 20 of headlight and dimmer switch
wiring harness (see WP 0214 00). If voltage is not present, go to step 7.
4.
Loosen six screws (6) and remove cover (7) and lamp. Place red lead of multimeter in socket and black
lead to ground. Turn MASTER switch ON, press B.O. MARKER key and ENTER key on main light
switch, and check for voltage. Turn MASTER and main lighting switches OFF. If voltage is present,
replace lamp (see WP 0179 00). If voltage is not present, go to step 5.
0083 00-5
