TM 9-2350-256-20-1
0082 00
CORRECTIVE ACTION Continued
10. Reconnect wire 75/16 to stoplight switch. Disconnect wire 75 from stoplight switch. Place red lead
of multimeter on wire 75 of stoplight switch and black lead to ground. Turn MASTER switch ON,
press B.O. MARKER key and ENTER key on main light switch, press stoplight switch (vehicle brake),
and check for voltage. If voltage is present, repair/replace wire 75 of switch panel to gage panel and
miscellaneous switches wiring harness (see WP 0204 00 for dual voltage; 0205 00 for single voltage).
If voltage is not present, replace stoplight switch (see WP 0172 00).
11. Reconnect switch panel to gage panel and miscellaneous switches wiring harness to main switch panel.
Install main switch panel (11), flat washer (10), ground lead (9), three lockwashers (8), and three screws
(7). Open air inlet doors. Disconnect wire 48 pin A from bulkhead to master relay wiring harness.
Place red multimeter lead in socket and black lead to ground. Turn MASTER switch on and check for
voltage. If voltage is present, repair/replace switch panel, radio, and bilge pump to bulkhead wiring
harness (see WP 0202 00). If voltage is not present, troubleshoot master relay circuit (see WP 0042 00).
END OF WORK PACKAGE
0082 00-7/8 blank
