TM 9-2350-256-20-1
0144 00
2.
Remove cotter pin (4), nut (5), and flat washer (6).
NOTE
Do not separate hub and fan, as this will affect the balance of the assembly.
NOTE
Both forward and rear hub and fan assemblies are interchangeable.
3.
Remove assembled fan (7) and hub (8).
Installation
1.
Install assembled fan (7) and hub (8) on splined vehicle shaft.
2.
Install flat washer (6) and nut (5). Torque nut to 50 pound-feet (lb-ft) (68 newton-meters [Nm] ).
3.
Align slot with hole in shaft and install cotter pin (4).
0144 00-2
