TM 9-2350-256-20-2
0279 00
7.
Remove two bearing cups (23) from hub (22) using remover, replacer, handle, and hammer.
8.
Remove inner cone bearing (24), inner oil seal (25), and dirt deflector (26) from track support roller bracket (27).
Cleaning
WARNING
Solvents can burn easily, give off harmful vapors, and are harmful to skin and clothing. To avoid injury
or death, keep away from open flame and use in a well-ventilated area. If solvent gets on skin or clothing,
wash immediately with soap and water.
NOTE
Use only fresh cleaning compound for bearings.
1.
Clean all parts thoroughly using cleaning compound.
Inspection-Acceptance and Rejection Criteria
1.
Inspect all parts for wear, pitting, or other damage. Replace all defective parts.
Assembly
NOTE
Pack bearings with grease before assembling (refer to TM 9-2350-256-10).
1.
Install dirt deflector (26) and inner oil seal (25) onto track support roller bracket (27) using replacer and hammer.
2.
Install inner cone bearing (24).
3.
Install two bearing cups (23) onto hub (22) using remover, replacer, handle, and hammer.
0279 00-4
