TM 9-2350-256-20-2
0311 00
3.
Remove splash guard (3) and strip (10) by removing five screws (11) and five lockwashers (12).
4.
Remove hinged rear fender (4) by removing eight screws (13) and eight lockwashers (14).
5.
Remove rear fender (5) from support (15) by removing two screws (16) and two lockwashers (17).
NOTE
Any support (15) can be removed when fenders on both sides of support have been removed.
6.
Remove five supports (15) by removing from each screw (18) and lockwasher (19).
Disassembly
1.
Remove five pins (20) from five supports (15).
Assembly
Install five pins (20) in five supports (15).
1.
Installation
1.
Install five supports (15) each with screw (18) and lockwasher (19). Locate pins (20) in hull locating holes.
2.
Install rear fender (5) on support (15) with two lockwashers (17) and two screws (16).
3.
Install hinged rear fender (4) with eight screws (13) and eight lockwashers (14).
4.
Install splash guard (3) and strip (10) with five screws (11) and five lockwashers (12).
5.
Install each of four fenders (2) with eight screws (8) and eight lockwashers (9).
0311 00-2
