TM 9-2350-256-20-2
0362 00
Adjustment
WARNING
To prevent injury to personnel or damage to equipment, chock track (see WP 0483 00).
1.
Place shifting control in PARK (P) position.
2.
Push brake pedal down as far as possible. Brake pedal should lock in down position.
3.
If brake pedal does not lock in down position, loosen two locknuts on linkage rod. Loosen neutral safety switch adjustment
screw. Adjust rod until brake pedal will lock in down position. Tighten locknuts.
4.
Check to see if steering control lock engages recess in steering control (point 6). If lock is not engaged, loosen two locknuts
on steering control linkage rod. Adjust rod until lock engages recess in steering control. Tighten locknuts.
5.
After adjustment is made, hold brake pedal down and move shifting control to neutral. Move steering wheel left and right
to verify free movement of steering wheel. If lock remains engaged, readjust steering lock control rod linkage and reverify
free movement of steering wheel by repeating step 4 above.
6.
If lock will not seat completely, inspect to see if spring (point 7) is pushed against clevis. If spring is pushing against clevis,
replace spring.
7.
Check adjustment screw on neutral safety switch lever cross shaft (point 8) for contact with neutral safety switch. If
adjustment screw is not in contact with neutral safety switch, loosen locknut on adjustment screw. Adjust length of screw
until neutral safety switch is engaged.
NOTE
Follow-on maintenance: Check transmission oil pressure; Install batteries (see WP 0153 00); Install
powerplant (see WP 0098 00).
0362 00-2
