TM 9-2350-256-20-2
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
HYDRAULIC CONNECTING PANEL REPLACEMENT
REMOVAL, INSTALLATION
INITIAL SETUP:
Tools and Special Tools
Equipment Condition
Tool kit, general mechanic's (item 59, WP 0490 00)
Air cleaner (right-side) removed (see WP 0137 00)
Rear right-side floor plate removed (see WP 0291 00)
Materials/Parts
Hydraulic connections access cover removed (see WP
Sealant tape (item 34, WP 0489 00)
Gasket (item 29, WP 0491 00)
Lockwashers (10) (item 638, WP 0491 00)
Screws (10) (item 371, WP 0491 00)
WARNING
Hydraulic fluid under pressure can penetrate skin or damage eyes. Fluid leaks under pressure may not
be visible, use a piece of cardboard or wood to find leaks, but do not use bare hand. Wear safety goggles
for protection. If fluid enters skin or eye, get immediate medical attention.
WARNING
Do not attempt to loosen or tighten hydraulic fittings or lines when the system is pressurized. Ensure
that the boom is in the stowed position before doing any maintenance on the hydraulic system.
Removal
1.
Disconnect hydraulic lines on both sides of the bulkhead and tag each line with the port number from which it was removed.
0418 00-1
