TM 9-2350-256-20-2
0468 00
Installation
1.
Remove two cover plates (see WP 0343 00) on top of engine deck from exhaust stack by removing eight screws (1) and
eight lockwashers (2). Retain screws.
2.
Remove two existing elbows (3) by removing two clamps (4) and retain.
3.
Install two kit-furnished flexible exhaust pipes (5) on engine exhaust outlets using kit-furnished clamp (6) and seal (7).
Apply adhesive sealant (item 4, WP 0465 00) to pipe flange (8).
4.
Install four kit-furnished clamps (9) with eight previously removed screws (1) and eight lockwashers (2).
5.
Install two previously removed elbows (3) on flexible exhaust pipes (5) each with previously removed clamp (4). Apply
adhesive sealant (item 4, WP 0465 00) around joint to prevent entry of water.
6.
Start and operate engine (refer to TM 9-2350-256-10). While exhaust system is hot, tighten all exhaust system clamped
joints.
END OF WORK PACKAGE
0468 00-2
