TM 9-2350-256-20CHAPTER 9:MAINTENANCE OF HULL- AND CAB-RELATED COMPONENTS9-85 REPLACE LEVER ASSEMBLY-CONTINUEDb. ASSEMBLY1Install bearing (4) into lever (2) making sure thatbearing hole alines with hole for lubrication fittingin lever.NOTESeals (3) must be installed with rubber lipsfacing outward.2Install two new seals (3) into lever (2).3Install lubrication fitting (1) into lever (2).4Lubricate in accordance with Appendix J.NOTEFollow-on maintenance:Install lever assembly (see paragraph 9-80)9-86 REPLACE LINKAGE ROLLER PLATESTHIS TASK COVERSa. Removalb. InstallationINITIAL SET-UPTools:Parts:Tool kit, general mechanic’s (Appendix C, item 53)Lockwashers (6) (Appendix G, item 134)NOTERemoval and installation procedures are the same for all three linkage roller plates.a. REMOVAL1Removal eight bolts (1) and eight rollers (2) fromlinkage roller plate (3).2Remove linkage roller plate (3) by removing twonuts (A), two lockwashers (5), and two flat washers(6).b. INSTALLATION1Install linkage roller plate (3) with two flat washers(6), two new lockwashers (5). and two nuts (4).2Install eight rollers (2) and eight bolts (1) to linkageroller plate (3).9 - 2 0 8Change 1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business