TM 9-2350-256-20CHAPTER 9:MAINTENANCE OF HULL- AND CAB-RELATED COMPONENTS9-87 REPLACE VISE MOUNTING HARDWARE AND ADAPTER PLATE-ContinuedNOTEThe M88A1 uses either a three- or four-mounting-hole vise. The four-mounting-hole vise procedureis shown.a. REMOVAL1Remove vise (1) by removing four screws (2), fourlockwashers (3), and four flat washers (4).NOTEVise adapter plate is required only whenthree-mounting-hole vise is used. Proceedwith step 2 only if necessary.2Remove vise adapter plate (5) by removing fourscrews (6), four lockwashers (7), and four flatwashers (8).b. INSTALLATION1Install vise adapter plate (5) by installing four flatwashers (8), four new lockwashers (7), and fourscrews (6).2Install vise (1) by installing four flat washers (4),four new lockwashers (3), and four screws (2).9 - 2 1 2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business