DISASSEMBLY - TM-9-2350-256-20

DISASSEMBLY (cont) - TM-9-2350-256-20_1243

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
1229

CHAPTER 14: MAINTENANCE OF MBA3 GAS/PARTICULATE FILTER UNIT TM 9-2350-256-20 14-1 REPLACE/REPAIR M8A3 FILTER UNIT SYSTEM-Continued b. DISASSEMBLY NOTE Step 1 applies only to driver's hose. 1 Separate hoses (1 and 2) by removing two clamps (3) and tube (4). 2 Disassemble hose assembly by removing coupling half (5) and clamp (6) from each end of hose (7). 3 Disassemble electrical cable assemblies and wire lead (see Chapter 6, Section VII). c. ASSEMBLY 1 Assemble hose assembly by installing coupling half (5) and clamp (6) to each end of hose (7). NOTE Step 2 applies only to driver's hose. 2 Connect hoses (1 and 2) to each other with two clamps (3) and tube (4). 3 Assemble electrical cable assemblies and wire lead (see Chapter 6, Section VII). d. INSTALLATION Left Side 1 Install frame assembly (45) with three screws (47) and three new lockwashers (48). 2 Install M2A2 air purifier (27) in frame assembly (45) and close catch assembly (46). 3 Install two clamps (37) and clamp (42) each with screw (43) and new lockwasher (44). 4 Connect and install AFT passenger's hose (41) on manifold of M2A2 air purifier (27) and clamp (42). 5 Connect and install driver's hose (35) and FWD passenger's hose (36) on manifold of M2A2 air purifier (27) and clamps (37). Secure hoses to vehicle with 12 clamps (38). Each pair of clamps is held by screw (39) and new lockwasher (40). 6 Install circuit breaker and switch assembly (26) with two screws (33) and two new lockwashers (34). 14-6

Privacy Statement
Press Release
Contact